Safety data sheet

Cartridge Resistances for Exclusive Use in Industrial Environments.
Heating resistance with high concentration in W/cm² that develops high temperatures.
Severe burns may occur if skin comes into contact with heating system parts.
The installation process of a cartridge requires expert and certified knowledge on the part of the installer.
It is necessary to use goggles, safety gloves, and clothing suitable for high temperatures.

Installation

Indicate hot surface warning with symbols.
Store in as dry a place as possible.
Disconnect total power from the machine or mould.
Check that the machine or mould is at room temperature.
Insertion without any type of anti-seize paste.
Holes with H7 tolerance only.
Attach control and cut-off systems (thermocouples and regulators).
Insertion of 100% of the cartridge sheath length.
Do not insert the connection cable inside the hole.
Protect cables and cartridge connection entry from impacts, splashes, and excess material.
Do not lift or carry the heater by the cable.
Keep the cable away from and protected from the heat source.
Do not repair damaged cables. Replace them with new ones identical to the originals.
Indicate and submit in writing the working conditions (vibration, shocks, humid environments) before order acceptance.
Never leave running without qualified human presence.
All exposed parts are mandatory for the safety of persons and property.